SIST EN 60512-11-3:2003

SLOVENSKI SIST EN 60512-11-3:2003

STANDARD
oktober 2003
Connectors for electronic equipment - Tests and measurements - Part 11-3:
Climatic tests - Test 11c: Damp heat, steady state (IEC 60512-11-3:2002)
ICS 31.220.10 Referenčna številka
©  Standard je založil in izdal Slovenski inštitut za standardizacijo. Razmnoževanje ali kopiranje celote ali delov tega dokumenta ni dovoljeno

EUROPEAN STANDARD EN 60512-11-3
NORME EUROPÉENNE
EUROPÄISCHE NORM April 2002
ICS 31.220.10
English version
Connectors for electronic equipment -
Tests and measurements
Part 11-3: Climatic tests -
Test 11c: Damp heat, steady state
(IEC 60512-11-3:2002)
Connecteurs pour équipements Steckverbinder für elektronische
électroniques - Einrichtungen -
Essais et mesures Mess- und Prüfverfahren
Partie 11-3: Essais climatiques - Teil 11-3: Klimatische Prüfungen -
Essai 11c: Essai continu Prüfung 11c: Feuchte Wärme, konstant
de chaleur humide (IEC 60512-11-3:2002)
(CEI 60512-11-3:2002)
This European Standard was approved by CENELEC on 2002-04-01. CENELEC members are bound to
comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration.
Up-to-date lists and bibliographical references concerning such national standards may be obtained on
application to the Central Secretariat or to any CENELEC member.
This European Standard exists in three official versions (English, French, German). A version in any other
language made by translation under the responsibility of a CENELEC member into its own language and
notified to the Central Secretariat has the same status as the official versions.
CENELEC members are the national electrotechnical committees of Austria, Belgium, Czech Republic,
Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands,
Norway, Portugal, Spain, Sweden, Switzerland and United Kingdom.
CENELEC
European Committee for Electrotechnical Standardization
Comité Européen de Normalisation Electrotechnique
Europäisches Komitee für Elektrotechnische Normung
Central Secretariat: rue de Stassart 35, B - 1050 Brussels
© 2002 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members.
Ref. No. EN 60512-11-3:2002 E
Foreword
The text of document 48B/1144/FDIS, future edition 1 of IEC 60512-11-3, prepared by SC 48B,
Connectors, of IEC TC 48, Electromechanical components and mechanical structures for electronic
equipment, was submitted to the IEC-CENELEC parallel vote and was approved by CENELEC as
EN 60512-11-3 on 2002-04-01.
The following dates were fixed:
– latest date by which the EN has to be implemented
at national level by publication of an identical
national standard or by endorsement (dop) 2003-01-01
– latest date by which the national standards conflicting
with the EN have to be withdrawn (dow) 2005-04-01
Annexes designated "normative" are part of the body of the standard.
In this standard, annex ZA is normative.
Annex ZA has been added by CENELEC.
__________
Endorsement notice
The text of the International Standard IEC 60512-11-3:2002 was approved by CENELEC as a European
Standard without any modification.
__________
- 3 - EN 60512-11-3:2002
Annex ZA
(normative)
Normative references to international publications
with their corresponding European publications
This European Standard incorporates by dated or undated reference, provisions from other
publications. These normative references are cited at the appropriate places in the text and the
publications are listed hereafter. For dated references, subsequent amendments to or revisions of any
of these publications apply to this European Standard only when incorporated in it by amendment or
revision. For undated references the latest edition of the publication referred to applies (including
amendments).
NOTE When an international publication has been modified by common modifications, indicated by (mod), the relevant
EN/HD applies.
Publication Year Title EN/HD Year
1)
IEC 60068-2-3 1969 Basic environmental testing procedures HD 323.2.3 S2 1987
Part 2: Tests - Test Ca: Damp heat,
steady state
2) 3)
IEC 60512-1-1 - Connectors for electronic equipment - EN 60512-1-1 2002
Tests and measurements
Part 1-1: General examination - Test 1a:
Visual examination
2) 3)
IEC 60512-2-1 - Part 2-1: Electrical continuity and EN 60512-2-1 2002
contact resistance tests - Test 2a:
Contact resistance - Millivolt level
method
2) 3)
IEC 60512-3-1 - Part 3-1: Insulation tests - Test 3a: EN 60512-3-1 2002
Insulation resistance
4)
IEC 60512-4-1 - Part 4-1: Voltage stress tests - Test 4a:--
Voltage proof
IEC 60512-7 1993 Part 7: Mechanical operating tests and--
sealing tests
1)
HD 323.2.3 S2 includes A1:1984 to IEC 60068-2-3.
2)
Undated reference.
3)
Valid edition at date of issue.
4)
In preparation.
NORME CEI
INTERNATIONALE IEC
60512-11-3
INTERNATIONAL
Première édition
STANDARD
First edition
2002-02
Connecteurs pour équipements électroniques –
Essais et mesures –
Partie 11-3:
Essais climatiques –
Essai 11c: Essai continu de chaleur humide
Connectors for electronic equipment –
Tests and measurements –
Part 11-3:
Climatic tests –
Test 11c: Damp heat, steady state
 IEC 2002 Droits de reproduction réservés  Copyright - all rights reserved
Aucune partie de cette publication ne peut être reproduite ni No part of this publication may be reproduced or utilized in any
utilisée sous quelque forme que ce soit et par aucun procédé, form or by any means, electronic or mechanical, including
électronique ou mécanique, y compris la photocopie et les photocopying and microfilm, without permission in writing from
microfilms, sans l'accord écrit de l'éditeur. the publisher.
International Electrotechnical Commission, 3, rue de Varembé, PO Box 131, CH-1211 Geneva 20, Switzerland
Telephone: +41 22 919 02 11 Telefax: +41 22 919 03 00 E-mail: inmail@iec.ch  Web: www.iec.ch
CODE PRIX
E
PRICE CODE
Commission Electrotechnique Internationale
International Electrotechnical Commission
Международная Электротехническая Комиссия
Pour prix, voir catalogue en vigueur
For price, see current catalogue

60512-11-3  IEC:2002 – 3 –
INTERNATIONAL ELECTROTECHNICAL COMMISSION
____________
CONNECTORS FOR ELECTRONIC EQUIPMENT –
TESTS AND MEASUREMENTS –
Part 11-3: Climatic tests –
Test 11c: Damp heat, steady state
FOREWORD
1) The IEC (International Electrotechnical Commission) is a worldwide organization for standardization comprising
all national electrotechnical committees (IEC National Committees). The object of the IEC is to promote
international co-operation on all questions concerning standardization in the electrical and electronic fields. To
this end and in addition to other activities, the IEC publishes International Standards. Their preparat
...