Unbound mixtures - Specification

The purpose of the European Standard is - with appropriate regard to other relevant European Standards - to provide technical requirements in terms of specifications, test methods and compliance criteria for unbound mixtures used for construction and maintenance of roads, airfields and other trafficked areas. The requirements of this Standard apply to unbound mixtures for road pavements at the point of delivery.

Ungebundene Gemische - Anforderungen

Diese Europäische Norm legt Anforderungen an ungebundene Gemische fest, die beim Bau und bei der Instandhaltung von Straßen, Flugplätzen und anderen Verkehrsflächen angewendet werden. Die Anforderungen werden unter entsprechenden Querverweisen auf EN 13242 festgelegt.
Diese Europäische Norm gilt für ungebundene Gemische aus natürlichen, künstlichen und recycelten Gesteinskörnungen (siehe Anhang A) mit einer oberen Siebgröße (D) von 8 mm bis 80 mm und einer unteren Siebgröße (d) = 0 bei der Auslieferung.
ANMERKUNG 1   Gemische mit einer oberen Siebgröße (D) größer als 80 mm werden in dieser Europäischen Norm nicht erfasst, dürfen jedoch unter den am Verwendungsort geltenden Bedingungen eingesetzt werden.
ANMERKUNG 2   Der Wassergehalt des Gemisches und die Dichte der eingebauten Schicht sind keine für die Gemische vorgeschrieben Anforderungen. Beide Eigenschaften hängen von der Überwachung der eingebauten Schicht ab und liegen außerhalb des Anwendungsbereichs dieser Europäischen Norm.

Graves non traitées - Spécifications

Cette Norme européenne spécifie les spécifications pour les mélanges non traités utilisés pour la construction et l'entretien des routes, des aérodromes et d'autres aires de trafic. Ces exigences sont définies en accord avec l'EN 13242.
Cette Norme européenne s'applique aux mélanges non traités de granulats naturels, artificiels et recyclés (voir annexe A) avec une dimension maximale des grains (D) comprise entre 8 mm et 80 mm et une dimension minimale des grains (d) = 0 à la livraison.
NOTE 1   Les mélanges dont la dimension maximale des grains (D) dépasse 80 mm ne sont pas couverts par cette Norme européenne mais peuvent être spécifiés sur les lieux d'utilisation.
NOTE 2   La teneur en eau du mélange et la masse volumique de la couche mise en place ne sont pas des exigences spécifiées. Ces deux paramètres concernent le contrôle de la construction de la couche et sortent du cadre de cette Norme européenne.

Nevezane zmesi – Specifikacija

General Information

Status
Withdrawn
Publication Date
31-May-2004
Withdrawal Date
25-Oct-2010
Technical Committee
Current Stage
9900 - Withdrawal (Adopted Project)
Start Date
25-Oct-2010
Due Date
17-Nov-2010
Completion Date
26-Oct-2010

Relations

Effective Date
01-Dec-2010

Buy Standard

Standard
EN 13285:2004
English language
23 pages
sale 10% off
Preview
sale 10% off
Preview
e-Library read for
1 day

Standards Content (Sample)


2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Nevezane zmesi – SpecifikacijaUngebundene Gemische - AnforderungenGraves non traitées - SpécificationsUnbound mixtures - Specification93.080.20Materiali za gradnjo cestRoad construction materialsICS:Ta slovenski standard je istoveten z:EN 13285:2003SIST EN 13285:2004en01-junij-2004SIST EN 13285:2004SLOVENSKI
STANDARD
EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 13285April 2003ICS 93.080.20English versionUnbound mixtures - SpecificationGraves non traitées - SpécificationsUngebundene Gemische - AnforderungenThis European Standard was approved by CEN on 12 December 2002.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the officialversions.CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,Hungary, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and UnitedKingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2003 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 13285:2003 ESIST EN 13285:2004

Description of mixtures containing recycled aggregates.12Annex B (informative)
Use of the supplier declared value.15Annex C (informative)
Guidance on the assessment of the mechanical behaviour of unboundmixtures.17Annex D (normative)
Factory production control.18Bibliography.23SIST EN 13285:2004
...

Questions, Comments and Discussion

Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.