ASTM D4805-88(1994)e1

NOTICE: This standard has either been superceded and replaced by a new version or discontinued.
Contact ASTM International (www.astm.org) for the latest information.
e1
Designation: D 4805 – 88 (Reapproved 1994)
Standard Terminology for
Plastics Standards
This standard is issued under the fixed designation D 4805; the number immediately following the designation indicates the year of
original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A
superscript epsilon (e) indicates an editorial change since the last revision or reapproval.
e NOTE—Sections 1 and 2 were corrected editorially in December 1994.
1. Scope E 375 Definitions of Terms Relating to Resinography
[D-20.92, D-20.71]
1.1 This standard provides a compilation of terminology in
2.3 Nonterminology Standards Within Committee D-20—
the standards under the jurisdiction of Committee D-20 on
The number of each standard from which standard termi-
Plastics.
nology was taken is included in parentheses and identifi-
1.2 It is the purpose of this standard to provide a single
cation of the subcommittee with jurisdiction is included in
source for terms and their definitions that have been standard-
brackets at the end of the definition.
ized by the consensus process within Committee D-20 on
Plastics. It is not the purpose of this standard to provide a
3. Terminology
medium for standardizing terms and definitions.
3.1 Definitions:
2. Referenced Documents 3.2 Acronyms:standard terminology, n.—a word, phrase,
symbol, acronym, or abbreviation that has been given explicit
2.1 ASTM Standards:
meaning in ASTM Standards by the consensus procedure.
2.2 Terminology Standards within Committee D-20
4. Tables of Terminology
D 883 Terminology Relating to Plastics [D-20.92]
4.1 Standard terms and their definitions under the jurisdic-
D 1600 Terminology of Abbreviated Terms Relating to
2 tion of Committee D-20 on Plastics will be listed alphabetically
Plastics [D-20.92]
in this section followed by a second alphabetical list of the
D 3016 Practice for Use of Liquid Exclusion Chromatogra-
3 standard abbreviations, acronyms, and symbols that also are
phy Terms and Relationships [D-20.70]
under the jurisdiction of Committee D-20.
D 3918 Definitions of Terms Relating to Reinforced Plastic
Pultruded Products [D-20.18]
NOTE 1—These listings of terminology already standardized by the
D 4092 Terminology Relating to Dynamic Mechanical consensus process is an editorial change and does not require separate
balloting.
Measurements on Plastics [D-20.10]
4.2 Appendix—The appendix contains reference to ASTM
Terminology standards that cover technical fields closely
related to plastics, terminology standards from other organiza-
tions, and references to publications that provide assistance in
This terminology is under the jurisdiction of ASTM Committee D-20 on
developing good technical terminology.
Plastics and is the direct responsibility of Subcommittee D20.92 on Definitions.
Current edition approved March 25, 1988. Published December 1988.
Annual Book of ASTM Standards, Vol 08.01.
3 4
Annual Book of ASTM Standards, Vol 08.02. Discontinued—See Annual Book of ASTM Standards, Vol 08.03.
Copyright © ASTM International, 100 Barr Harbor Drive, PO B
...