ISO/TC 29/SC 10/WG 3 - Hand torque tools
Outils dynamométriques
General Information
This document specifies the minimum requirements for interim checking of the torque output of hand torque tools used for controlled tightening of screws and nuts. This document applies to hand torque tools which are classified as indicating torque tools (Type I) and setting torque tools (Type II). This document does not specify requirements of calibration certificates for hand torque tools. These are described in ISO 6789-2.
- Draft17 pagesEnglish languagesale 15% off
- Draft23 pagesFrench languagesale 15% off
Frequently Asked Questions
ISO/TC 29/SC 10/WG 3 is a Subcommittee within the International Organization for Standardization (ISO). It is named "Hand torque tools". This committee has published 1 standards.
ISO/TC 29/SC 10/WG 3 develops ISO standards in the area of Information technology. Currently, there are 1 published standards from this subcommittee.
The International Organization for Standardization (ISO) is an independent, non-governmental international organization that develops and publishes international standards. Founded in 1947 and headquartered in Geneva, Switzerland, ISO brings together experts from 170+ member countries to share knowledge and develop voluntary, consensus-based standards that support innovation and provide solutions to global challenges.
A Subcommittee (SC) in ISO operates under a Technical Committee and focuses on a specific subset of the TC's scope. Subcommittees develop standards and technical specifications in their specialized area, reporting to their parent Technical Committee. They may also have working groups for detailed technical work.