SIST EN 301 929-2 V1.1.1:2004

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Electromagnetic compatibility and Radio spectrum Matters (ERM); VHF transmitters and receivers as Coast Stations for GMDSS and other applications in the maritime mobile service; Part 2: Harmonized EN under article 3.2 of the R&TTE Directive33.100.01Elektromagnetna združljivost na splošnoElectromagnetic compatibility in general33.060.20Sprejemna in oddajna opremaReceiving and transmitting equipmentICS:Ta slovenski standard je istoveten z:EN 301 929-2 Version 1.1.1SIST EN 301 929-2 V1.1.1:2004en01-oktober-2004SIST EN 301 929-2 V1.1.1:2004SLOVENSKI
STANDARD
ETSI ETSI EN 301 929-2 V1.1.1 (2002-01) 2
Reference DEN/ERM-RP01-041-2 Keywords maritime, VHF, radio, GMDSS, regulation ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE
Tel.: +33 4 92 94 42 00
Fax: +33 4 93 65 47 16
Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88
Important notice Individual copies of the present document can be downloaded from: http://www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http://portal.etsi.org/tb/status/status.asp If you find errors in the present document, send your comment to: editor@etsi.fr Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media.
© European Telecommunications Standards Institute 2002. All rights reserved.
ETSI ETSI EN 301 929-2 V1.1.1 (2002-01) 3 Contents Intellectual Property Rights.6 Foreword.6 Introduction.7 1 Scope.9 2 References.9 3 Definitions and abbreviations.10 3.1 Definitions.10 3.2 Abbreviations.10 4 Technical requirements specifications.10 4.1 Environmental profile.10 4.2 Conformance requirements.10 4.2.1 Transmitter frequency error.10 4.2.1.1 Definition.10 4.2.1.2 Limits.11 4.2.1.3 Conformance.11 4.2.2 Transmitter carrier power.11 4.2.2.1 Definition.11 4.2.2.2 Limits.11 4.2.2.3 Conformance.11 4.2.3 Transmitter frequency deviation.11 4.2.3.1 Definition.11 4.2.3.2 Limits.11 4.2.3.3 Conformance.11 4.2.4 Transmitter adjacent channel power.11 4.2.4.1 Definition.11 4.2.4.2 Limits.11 4.2.4.3 Conformance.11 4.2.5 Transmitter conducted spurious emissions conveyed to the antenna.11 4.2.5.1 Definition.11 4.2.5.2 Limits.12 4.2.5.3 Conformance.12 4.2.6 Transmitter cabinet radiation and conducted spurious emissions other than those conveyed to the antenna.12 4.2.6.1 Definition.12 4.2.6.2 Limits.12 4.2.6.3 Conformance.12 4.2.7 DSC transmitter modulation index.12 4.2.7.1 Definition.12 4.2.7.2 Limits.12 4.2.7.3 Conformance.12 4.2.8 Transient frequency behaviour of the transmitter.12 4.2.8.1 Definitions.12 4.2.8.2 Limits.12 4.2.8.3 Conformance.12 4.2.9 Intermodulation attenuation.13 4.2.9.1 Definitions.13 4.2.9.2 Limits.13 4.2.9.3 Conformance.13 4.2.10 Receiver maximum usable sensitivity.13 4.2.10.1 Definition.13 4.2.10.2 Limits.13 4.2.10.3 Conformance.13 4.2.11 Receiver co-channel rejection.13 SIST EN 301 929-2 V1.1.1:2004

ETSI ETSI EN 301 929-2 V1.1.1 (2002-01) 4 4.2.11.1 Definition.13 4.2.11.2 Limits.13 4.2.11.3 Conformance.13 4.2.12 Receiver adjacent channel selectivity.13 4.2.12.1 Definition.13 4.2.12.2 Limit.13 4.2.12.3 Conformance.13 4.2.13 Receiver spurious response.14 4.2.13.1 Definition.14 4.2.13.2 Limit.14 4.2.13.3 Conformance.14 4.2.14 Receiver intermodulation response.14 4.2.14.1 Definition.14 4.2.14.2 Limit.14 4.2.14.3 Conformance.14 4.2.15 Receiver blocking or desensitization.14 4.2.15.1 Definition.14 4.2.15.2 Limit.14 4.2.15.3 Conformance.14 4.2.16 Receiver spurious emissions at the antenna.14 4.2.16.1 Definition.14 4.2.16.2 Limit.14 4.2.16.3 Conformance.15 4.2.17 Receiver cabinet radiated spurious emissions.15 4.2.17.1 Definition.15 4.2.17.2 Limit.15 4.2.17.3 Conformance.15 4.2.18 DSC receiver maximum usable sensitivity.15 4.2.18.1 Definition.15 4.2.18.2 Limit.15 4.2.18.3 Conformance.15 4.2.19 DSC receiver co-channel rejection.15 4.2.19.1 Definition.15 4.2.19.2 Limit.15 4.2.19.3 Conformance.15 4.2.20 DSC receiver adjacent channel selectivity.15 4.2.20.1 Definition.15 4.2.20.2 Limit.15 4.2.20.3 Conformance.16 4.2.21 Receiver desensitization with simultaneous transmission and reception (duplex operation).16 4.2.21.1 Definition.16 4.2.21.2 Limit.16 4.2.21.3 Conformance.16 5 Testing for compliance with technical requirements.16 5.1 Test conditions, power supply and ambient temperatures.16 5.2 Interpretation of the measurement results.16 5.3 Essential radio test suites.17 5.3.1 Transmitter frequency error.17 5.3.2 Transmitter carrier power.17 5.3.3 Transmitter frequency deviation.17 5.3.4 Transmitter adjacent channel power.17 5.3.5 Transmitter conducted spurious emissions conveyed to the antenna.17 5.3.6 Transmitter cabinet radiation and conducted spurious emissions other than those conveyed to the antenna.18 5.3.7 DSC transmitter modulation index.18 5.3.8 Transient frequency behaviour of the transmitter.18 5.3.9 Intermodulation attenuation.18 5.4 Other test specifications.18 5.4.1 General.18 5.4.2 Receiver maximum usable sensitivity.18 5.4.3 Receiver co-channel rejection.18 SIST EN 301 929-2 V1.1.1:2004

ETSI ETSI EN 301 929-2 V1.1.1 (2002-01) 5 5.4.4 Receiver adjacent channel selectivity.18 5.4.5 Receiver spurious response.18 5.4.6 Receiver intermodulation response.18 5.4.7 Receiver blocking or desensitization.19 5.4.8 Receiver spurious emissions at the antenna.19 5.4.9 Receiver cabinet radiated spurious emissions.19 5.4.10 DSC receiver maximum usable sensitivity.19 5.4.11 DSC receiver co-channel rejection.19 5.4.12 DSC receiver adjacent channel selectivity.19 5.4.13 Receiver desensitization with simultaneous transmission and reception (duplex operation).19 Annex A (normative): The EN Requirements Table (EN-RT).20 Annex B (informative): The EN title in the official languages.22 History.23
ETSI ETSI EN 301 929-2 V1.1.1 (2002-01) 6 Intellectual Property Rights IPRs essential or potentially essential to the present document may have been declared to ETSI. The information pertaining to these essential IPRs, if any, is publicly available for ETSI members and non-members, and can be found in ETSI SR 000 314: "Intellectual Property Rights (IPRs); Essential, or potentially Essential, IPRs notified to ETSI in respect of ETSI standards", which is available from the ETSI Secretariat. Latest updates are available on the ETSI Web server (http://webapp.etsi.org/IPR/home.asp). Pursuant to the ETSI IPR Policy, no investigation, including IPR searches, has been carried out by ETSI. No guarantee can be given as to the existence of other IPRs not referenced in ETSI SR 000 314 (or the updates on the ETSI Web server) which are, or may be, or may become, essential to the present document. Foreword This Candidate Harmonized European Standard (Telecommunications series) has been produced by ETSI Technical Committee Electromagnetic compatibility and Radio spectrum Matters (ERM). The present document has been produced by ETSI in response to a mandate from the European Commission issued under Council Directive 98/34/EC (as amended) laying down a procedure for the provision of information in the field of technical standards and regulations. The present document is intended to become a Harmonized Standard, the reference of which will be published in the Official Journal of the European Communities referencing the Directive 1999/5/EC of the European Parliament and of the Council of 9 March 1999 on radio equipment and telecommunications terminal equipment and the mutual recognition of their conformity ("the R&TTE Directive" [1]). The present document is part 2 of a multi-part deliverable covering VHF transmitters and receivers as Coast Stations for GMDSS and other applications in the maritime mobile service, as identified below: Part 1: "Technical characteristics and methods of measurement"; Part 2: "Harmonized EN under article 3.2 of the R&TTE Directive". Technical specifications relevant to Directive 1999/5/EC [1] are given in annex A.
National transposition dates Date of adoption of this EN: 11 January 2002 Date of latest announcement of this EN (doa): 30 April 2002 Date of latest publication of new National Standard or endorsement of this EN (dop/e):
31 October 2002 Date of withdrawal of any conflicting National Standard (dow): 31 October 2003
ETSI ETSI EN 301 929-2 V1.1.1 (2002-01) 7 Introduction The present document is part of a set of standards designed to fit in a modular structure to cover all radio and telecommunications terminal equipment under the R&TTE Directive [1]. Each standard is a module in the structure. The modular structure is shown in figure 1.
- If needed, new standards for human exposure to Electromagnetic Fields, - if needed, new standards for acoustic safety Use of spectrum * If needed Scoped by
equipment
class or type Scoped by frequency and/or equipment type Disability* Privacy* Fraud* No harm to the network* Emergency* Interworking via
the network* Interworking with the network Non-radio Radio (RE) Non-TTE TTE 3.1b 3.2 3.3c 3.3b 3.3a 3.3d 3.3e 3.3f Radio Product EMC EN 301 489 multi-part EMC standard Generic and product standards also notified under EMC Directive Standards also notified under LV Directive 3.1a New radio harmonized standards Spectrum EMC Safety
Figure 1: Modular structure for the various standards used under the R&TTE Directive SIST EN 301 929-2 V1.1.1:2004

ETSI ETSI EN 301 929-2 V1.1.1 (2002-01) 8 The left hand edge of the figure 1 shows the different clauses of article 3 of the R&TTE Directive [1]. For article 3.3 various horizontal boxes are shown. Dotted lines indicate that at the time of publication of the present document essential requirements in these areas have to be adopted by the Commission. If such essential requirements are adopted, and as far and as long as they are applicable, they will justify individual standards whose scope is likely to be specified by function or interface type. The vertical boxes show the standards under article 3.2 for the use of the radio spectrum by radio equipment. The scopes of these standards are specified either by frequency (normally in the case where frequency bands are harmonized) or by radio equipment type. For article 3.1b the diagram shows EN 301 489 [7
...