SIST EN 13353:2004

2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.Massivholzplatten (SWP) - AnforderungenBois panneautés (SWP) - ExigencesSolid wood panels (SWP) - Requirements79.060.99Other wood-based panelsICS:Ta slovenski standard je istoveten z:EN 13353:2003SIST EN 13353:2004en01-januar-2004SIST EN 13353:2004SLOVENSKI
STANDARD
EUROPEAN STANDARDNORME EUROPÉENNEEUROPÄISCHE NORMEN 13353June 2003ICS 79.060.99English versionSolid wood panels (SWP) - RequirementsBois panneautés (SWP) - ExigencesMassivholzplatten (SWP) - AnforderungenThis European Standard was approved by CEN on 13 February 2003.CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this EuropeanStandard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such nationalstandards may be obtained on application to the Management Centre or to any CEN member.This European Standard exists in three official versions (English, French, German). A version in any other language made by translationunder the responsibility of a CEN member into its own language and notified to the Management Centre has the same status as the officialversions.CEN members are the national standards bodies of Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece,Hungary, Iceland, Ireland, Italy, Luxembourg, Malta, Netherlands, Norway, Portugal, Slovakia, Spain, Sweden, Switzerland and UnitedKingdom.EUROPEAN COMMITTEE FOR STANDARDIZATIONCOMITÉ EUROPÉEN DE NORMALISATIONEUROPÄISCHES KOMITEE FÜR NORMUNGManagement Centre: rue de Stassart, 36
B-1050 Brussels© 2003 CENAll rights of exploitation in any form and by any means reservedworldwide for CEN national Members.Ref. No. EN 13353:2003 ESIST EN 13353:2004

Properties for structural and non structural applications.10Bibliography.11SIST EN 13353:2004

2) % for use in dry conditions, (10
3) %for use in humid conditions and (12
3) % for use in exterior conditions.If another moisture is necessary e.g. due to regional climatic condition the appropriate moisture content has to bespecified explicitly.4.3 Bonding quality4.3.1 GeneralThe bonding quality shall be determined in accordance with CEN/TS 13354 after the appropriate pretreatment foruse in dry, humid or exterior condition.4.3.2 Single layer solid wood panelThe lower 5-percentile of the shear strength, calculated in accordance with EN 326-1, shall not be less than2,5 N/mm2.The mean wood failure percentage of each panel shall be more than 40 %.4.3.3 Multi layer solid wood panelThe lower 5-percentile of the shear strength calculated in accordance with EN 326-1 shall not be less than0,8 N/mm2.The mean percentage wood failure of each panel shall be more than 40 %.4.3.4 AdhesiveWhere panels are intended for structural applications, a thermosetting adhesive shall be used for the bonding of thelayers to each other.4.4 Biological durabilityThe risk of attack for uses in dry, humid and exterior conditions is outlined in biological hazard classes 1, 2 and 3 ofEN 335-2:1992. Guidance on factors affecting durability and on precautionary measures which may be considerednecessary can be found in EN 335-2 and EN 460.SIST EN 13353:2004

420Bending strength perpendicular to the plan
...